DEWALT DCD1623N-XJ 18V XR Magnetic Drill Press with Flexvolt Advantage, Bare Unit
Featuring a permanent magnet which doesn't sap your batteries in order to stay attached to the steel, this cordless mag drill from DeWalt is their first entry into the field, immediately blowing away the competition in both cost and drilling capacity.
This machine, the DCD1623, can drill a 2 inch (50mm) diameter hole through 2 inches of structural grade steel. In order to keep safe while making these challenging holes, the tool has an E-Clutch. It constantly monitors the position of the tool and as soon as it detects it rotating, it automatically shuts it off to prevent it shifting too much.
There are two mechanical gears, but also a speed control dial. In low gear it will operate from 130 to 420 rpm, and in high gear it will run from 250 up to 810 rpm. Each gear has five speed settings for a total of ten different speeds, all listed in a handy chart on the machine body itself.
While this -N version of the tool is supplied without batteries or charger, it is capable of working from not only a 54V FlexVolt battery, but also an 18 Volt XR battery. However when used with a 54V FlexVolt battery, DeWalt's FlexVolt Advantage technology kicks in, giving you up to 32 percent more power than with an 18V battery.
Features
- Maximum drilling capacity of 50 mm with annual cutters(Best in Class Cordless Mag Drill)
- Brushless Motor provides corded drill performance and can complete up to 40x20mm Holes on 12 mm Steel per battery Charge (using 9Ah)
- On board LED light to illuminate the work surface
- Forward and Reverse options makes it convenient for tapping
- Perform Protect (GYRO): Lift-off detection: Detects excess rotation and automatically cuts power for best user protectio
- Permanent magnet with 9,9 KN of holding force prevents accidental magnet deactivation for improved user protection and easy alignment