How to Layout a Qwik Fence Application
The basic QWIK FENCE partition system is 8ft high using 5ft. wide x 4ft high galvanised welded wire panels ''stacked'' 2 high, tek screwed to a 2'' x 2'' galvanised line/corner post (part #8). The avaiable wall kit (part#WK) is normally used where the partition meets an existing wall, but a post can also be used in this location.
1. Make a sketch indicating the overall measurements and location of doors.
2. Layout the panels, posts and doors as shown below
3. Where less than 8ft. is required, figure standard 8ft. wide panels and field cut to the desired width using any standard wire cutter
4. When utilizing 8ft high door in a 10ft and 12ft high installation order a transom kit (TK-10 for 10ft high, TK-12 for 12ft high) and a standard panel.
QWIK FENCE Pre-Engineered Rooms
- Standard size room kits made up of components listed below
- Includes all panels, doors, posts and hardware needed for a complete room
- Installation instructions included with door hardware. Door is 4ft wide x 8ft high slide door with cylinder lock and keys
- Door located on width side